podezzyPODezzy

Left chest logo size and placement: 3.5 inches, and how much of each shirt it covers from youth XS to 5XL

A left chest logo is about 3.5 × 3.5 inches, or 1,050 × 1,050 px at 300 DPI. Four print guides compared on where it goes, and how much of each shirt the same logo covers when printed at one size: 21.9% of a youth XS, 10.9% of an adult 5XL.

Left chest logo size and placement: 3.5 inches, and how much of each shirt it covers from youth XS to 5XL

A left chest logo is about 3.5 × 3.5 inches, which is 525 × 525 pixels at 150 DPI or 1,050 × 1,050 at 300 DPI in Podezzy's Design Size Calculator. 4OVER4 and Underground Printing place it 3 to 4 inches down from the shoulder seam, and Transfer Express puts the top of the logo 3 inches below the collar on sizes M to XL. If your print partner prints your logo at the same size on every shirt, a 3.5 inch logo covers 21.9% of the width of a Gildan youth XS laid flat and 10.9% of an adult 5XL. In that case a youth XS file at about 3.1 inches and a youth S file at 3.3 match the look of the 3.5 inch preset on an adult S; if your partner scales artwork down for small sizes, as Printify does below size L, keep one 3.5 inch file.

Last checked November 13, 2026. Logo sizes and distances come from the placement guides published by 4OVER4, Underground Printing, Transfer Express and Printify. Shirt widths come from Gildan's 5000B spec sheet for youth sizes and Printful's Gildan 5000 listing for adult sizes. Etsy numbers are Podezzy's own snapshot from November 12, 2026.

Left chest logo size and placement in four print guides

4OVER4 recommends 3.5 to 4 inches wide, Underground Printing 3 to 4, Transfer Express under 4.5 (3 to 3.5 for round or square art), and Printify anything from 2.5 to 5 inches each way. They measure the position from different points on the shirt.

GuideLogo widthHow far downHow far across
4OVER43.5 to 4 in (youth 3 to 3.5 in)3 to 4 in below the shoulder seamAbout 4 in from the center
Underground Printing3 to 4 in, up to 3.5 in tall3 to 4 in down from the shoulder seamAbout 3 in from the side seam
Transfer ExpressUnder 4.5 in; 3 to 3.5 in for round or square art3 in from the bottom of the collar to the top of the logo (sizes M to XL)On a line straight down from where the collar meets the shoulder seam
Printify2.5 to 5 in each wayRoughly 4 to 6 in below the collarA few inches in from the center

Podezzy's Design Size Calculator uses 3.5 × 3.5 inches for its left chest preset, which fits all four width ranges. 4OVER4 gives the same 3.5 to 4 inches for height as for width, and Underground Printing caps the height at 3.5 inches, so a round or square logo at 3.5 inches suits both.

By Transfer Express's measure, a logo centered 3 inches from the side seam, as Underground Printing suggests, would sit on the side of the body: on a crewneck laid flat, Transfer Express notes, the 3 to 4 inches nearest the side edge wrap around the body when the shirt is worn. Transfer Express ties the position to the collar instead, and says its line keeps the print out of the armpit. Front, back and sleeve placements are covered in the t-shirt print size guide.

How much of the chest one logo covers, youth XS to adult 5XL

Printed at the same size, a 3.5 inch logo covers twice as much of a youth XS as of an adult 5XL. Gildan's youth 5000B goes from 16 inches across laid flat at XS to 20 at XL, and the adult Gildan 5000 from 18 inches at S to 32 at 5XL. Gildan's own retail store lists the youth 5000B in S to XL only, so the XS row applies where your print partner stocks that size.

SizeShirt width, flat (in)Share a 3.5 in logo coversLogo width at an adult S's 19.4% share (Podezzy calculation)
Youth XS1621.9%3.1 in
Youth S1720.6%3.3 in
Youth M1819.4%3.5 in
Youth L1918.4%3.7 in
Youth XL2017.5%3.9 in
Adult S1819.4%3.5 in
Adult M2017.5%3.9 in
Adult L2215.9%4.3 in
Adult XL2414.6%4.7 in
Adult 2XL2613.5%5.1 in
Adult 3XL2812.5%5.4 in
Adult 4XL3011.7%5.8 in
Adult 5XL3210.9%6.2 in

Youth widths are from Gildan's 5000B spec sheet. Adult widths are from Printful's catalog listing for the Gildan 5000, read November 13, 2026, which notes that measurements may vary by up to 2 inches. Share = 3.5 ÷ flat width. Logo width at an adult S's share = flat width × 3.5 ÷ 18.

A 3.5 inch left chest logo drawn to scale on a Gildan youth XS, an adult S and an adult 2XL, covering 21.9%, 19.4% and 13.5% of the shirt width when one file size is printed on every shirt; logo position illustrative

To look on a youth XS the way 3.5 inches looks on an adult S, the logo would be 3.1 inches wide, and on a youth S 3.3 inches. Both sit inside 4OVER4's 3 to 3.5 inch youth range, and Underground Printing advises adjusting design sizes proportionally for smaller or youth apparel. A youth M is 18 inches wide like an adult S, so from youth M up the 3.5 inch preset covers the same share as on an adult S or less. The full youth measurements are in the Gildan youth size chart.

Matching the adult S share on bigger adult shirts would take 3.9 inches on an M and 4.3 on an L, both past Transfer Express's 3 to 3.5 inches for round or square art, and 5.1 inches on a 2XL, past Printify's 5.

Which file you send depends on how your print partner sizes artwork. If it prints the file at the same size on every shirt and lets you send a separate file for the smallest sizes, send about 3.1 inches for youth XS and 3.3 for youth S, and keep 3.5 inches from youth M up. If it scales artwork down for smaller sizes, as Printify's Product Creator does on sizes below L, do not shrink the file yourself, or the small sizes get a logo reduced twice. Printify warns that a design that looks right on a medium can look oversized on smaller sizes, and recommends checking the mockup preview on each size and ordering a sample before you sell.

Where to measure from on each shirt size

Start from the point where the collar meets the shoulder seam. Transfer Express draws a line straight down from that point, centers the logo on it, then measures from the bottom of the collar to the top of the graphic.

The 3 inch drop is Transfer Express's figure for sizes M to XL. On smaller shirts it moves the logo up toward the collar, and on larger ones down. To check the height on extra small and extra large shirts, it centers the logo about a quarter of the way up the sleeve seam, because sleeves scale with the garment. Its advice is to always err on the high side, since a print that sits a little high is acceptable to wear and a low one is not.

Hands holding a tape measure straight down from where the collar meets the shoulder seam to a blank square transfer on the left chest of a navy t-shirt on a heat press

On some V-necks the left chest sits level with or above the collar line, and on a polo the buttons and seams have to stay off the press. For those, and for any garment you have not decorated before, Transfer Express cuts a piece of paper to the logo's size, tapes it on a worn shirt where it looks right, then lays the shirt flat and measures the spot.

The left chest file in pixels

A 3.5 inch square logo needs 1,050 × 1,050 pixels at 300 DPI and 525 × 525 at 150 DPI. Those are the numbers Podezzy's free Design Size Calculator returns for its Left chest preset (8.9 × 8.9 cm, checked November 13, 2026), and the tool's DPI help text puts the direct-to-garment floor at 150.

Other widths follow the same multiplication. The youth XS file at 3.1 inches is 465 × 465 pixels at 150 DPI and 930 × 930 at 300, and the youth S file at 3.3 inches is 495 × 495 and 990 × 990. A 4 inch logo is 600 × 600 and 1,200 × 1,200, the same 1,200 pixels 4OVER4 gives for a left chest at 300 DPI.

Podezzy Design Size Calculator with the left chest preset: 3.5 by 3.5 inches is 1,050 by 1,050 pixels at 300 DPI and 525 by 525 at 150 DPI, with youth XS and S files of 3.1 and 3.3 inches only for partners that print the size you set

The calculator also draws your design inside the placement and flags it when it overhangs, so a logo wider than 3.5 inches shows as too big for the preset. The preset area is fixed at 3.5 inches, so if your partner's left chest area is larger, go by your partner's template.

Left chest and pocket designs on Etsy

Under "left chest print", Podezzy's Etsy snapshot of November 12, 2026 counts 545 matched listings and an estimated 19 sales over the previous 30 days. None of its ten best sellers shows more than 3 estimated sales: five are custom text or logo listings, three are graphic designs (a "Girl Dad Club" tee, a beer slogan tee and an anime hoodie) and two are mockup files.

None of the ten best sellers under "custom logo shirt", "business logo shirt" or "company logo shirt" has "chest" or "pocket" in its title or tags, while front-and-back wording does appear, starting with the title of the top "custom logo shirt" listing, "Personalized Front & Back Print Shirt". In this snapshot the estimated sales sit under the product words.

TermMatched listingsEst. sales, 30 days
custom logo shirt14,39716,712
business logo shirt5,0135,284
company logo shirt3,1173,941
logo shirt2,920622
pocket tee4,538576
pocket shirt2,659213
custom pocket shirt413156
pocket design shirt67941
pocket print shirt54732
pocket logo shirt17826
small logo shirt23520
left chest print54519

Ten listings carry much of each big term: they hold 6,913 of the 16,712 estimated sales under "custom logo shirt", about 41%, and 2,361 of the 3,941 under "company logo shirt", about 60%. "Left chest logo shirt", "left chest shirt" and "embroidered logo shirt" are not in Podezzy's keyword data, so the snapshot has no figures for them.

Four folded t-shirts in white, sand, green and black laid in a row, each with a small blank round area on the left chest, next to kraft mailer bags

The pocket terms also catch listings that are not printed shirts: three of the "pocket tee" top ten are embroidery design files, and the "pocket shirt" top ten includes a sew-on pocket kit and a pen pocket protector. Under "pocket logo shirt", six of the nine best sellers checked, out of 178 matched listings, also carry the tag "business logo shirt".

What to do next

Ask your print partner whether it scales artwork down for smaller sizes, then size the files in the Design Size Calculator: the 3.5 inch Left chest preset for adult sizes and youth M to XL, plus 3.1 and 3.3 inch files for youth XS and S only if the partner prints every file at the size you set.

Left chest logo FAQ

What size should a left chest logo be on each shirt size?

About 3.5 inches square on adult sizes and from youth M up. If your partner prints one file size on every shirt, that logo covers 21.9% of a youth XS against 19.4% of an adult S, so a youth XS file at about 3.1 inches and a youth S file at 3.3 match the adult look. If your partner scales artwork down for small sizes, keep the 3.5 inch file.

How far down from the collar does a left chest logo go?

4OVER4 and Underground Printing say 3 to 4 inches down from the shoulder seam. Transfer Express measures 3 inches from the bottom of the collar to the top of the logo on sizes M to XL, higher on smaller shirts and lower on larger ones. Printify says roughly 4 to 6 inches below the collar.

What size should a youth left chest logo be?

4OVER4 puts it at 3 to 3.5 inches. From youth M up, the 3.5 inch adult preset covers no more of a Gildan youth shirt than it does of an adult S, so only youth XS and S need a smaller file, and only when your partner does not scale artwork down for small sizes.

Can you put the logo on the right chest instead?

Yes. Transfer Express's placement video covers left and right chest prints with the same steps.

How do you place a left chest logo in Printify?

Printify's guide puts the left chest roughly 4 to 6 inches below the collar and a few inches in from the center. Its Product Creator scales the design down on sizes below L, so send one file and check each size's mockup before you sell.

Every guide here has a tool behind it

Stop guessing. The tools are free and need no account.

Free lookups every day here — or unlimited research, rank tracking and bulk listing across four marketplaces on the full studio.

See the full studio →